Grazebook

Old 03-23-2011, 11:50 PM   #1
Ben
Member
 
Ben's Avatar
 
Join Date: Mar 2011
Location: Three Rivers Station, Meekatharra
Posts: 70
Question A “Bund Builder”

G’day folks, I’m looking to pre-fab a bucket for a FEL to form bunds with. I got the idea when “someone” bent the bucket on my loader.

I figure it would be much quicker to drop the dirt and then drive long the bund rather than having to work back and forth to the bund like traditional.

Has anyone had any success or experience with such an idea?
Ben is offline WA Australia   Reply With Quote
Old 09-05-2011, 06:56 PM   #2
Michael
Junior Member
 
Michael's Avatar
 
Join Date: Aug 2011
Location: Geraldton
Posts: 3
Default

How high and how wide are you aiming for?
Michael is offline WA Australia   Reply With Quote
Old 09-06-2011, 01:07 AM   #3
Ben
Member
 
Ben's Avatar
 
Join Date: Mar 2011
Location: Three Rivers Station, Meekatharra
Posts: 70
Default

Be about a foot high by two foot wide. Will try and get a photo up of some we have done with a normal bucket.
__________________
Turning red to green, a million acres at a time.
Ben is offline WA Australia   Reply With Quote
Old 09-06-2011, 07:46 PM   #4
Michael
Junior Member
 
Michael's Avatar
 
Join Date: Aug 2011
Location: Geraldton
Posts: 3
Default

I would be thinking something along the lines of a reversed snow plough. Cut the back and floor out of the old bucket, weld a few old grader blades in pointing to the centre and leave a hole the size you want your bund. Make the blades stick out further than you need and trim them back to suit. If they are too short they wouldn't gather enough dirt, too long you'd bulldoze too much and it would come over the top. If you're real keen tow a roller behind to pack it down. A tractor should clear the size your looking for, might need a bit of grunt though, an old chamberlian may not cut it. Actually, maybe leave the floor in to help stop it digging in, or skids maybe. I'm assuming the bunds would be fairly long and in open country.
Michael is offline WA Australia   Reply With Quote
Old 09-06-2011, 08:10 PM   #5
Ben
Member
 
Ben's Avatar
 
Join Date: Mar 2011
Location: Three Rivers Station, Meekatharra
Posts: 70
Default

At this stage for armouring the lip of erosion faces after they have been chamfered to about 20 degrees. The material then placed, either loader or hopefully side tipper (maybe belly dump...) in place. Then the loader forms it. I think it would require the bucket to be intact, if "buckled", to be able to continue to scrape up the excess material, meanwhile giving some compaction. I like the idea of a roller following, however, as most of these so far are a bit winding it would probably jump the bund too much.
All good food for thought thanks mate.
__________________
Turning red to green, a million acres at a time.
Ben is offline WA Australia   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +9.5. The time now is 08:00 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Template-Modifications by TMS
Grazebook © 2011